← Back to the recipe

Ingredients and steps on one page. Print it, or choose “Save as PDF” in the print dialog.

Sekai Gohan

Fried Walleye: Canadian Shore Lunch Fish in Cornmeal Crust

Pan-fried walleye fillets on a plate with a lemon wedge
Steps with photos

Ingredients

Ingredient Amount Role
Walleye fillets, skinless 2–3 fillets The fish: mild, sweet, flaky
Butter, for the seasoned dip ¼ cup (50 ml) Carries the seasoning and holds the coating on
Salt 1 tsp Seasoning
Pepper 1 tsp Seasoning
Onion powder 1 tsp Savory aroma
Garlic powder 1 tsp Savory aroma
All-purpose flour ¼ cup (50 ml) Binds the crust
Cornmeal ¼ cup (50 ml) Crunch and golden color
Italian seasoning 2 tsp Herb aroma in the crust
Butter, for frying 2 tbsp Frying fat and browned flavor
Lemon wedges as needed Squeezed over at the table

Steps

  1. 1Dry the fillets and check for bones

    Lay the fillets on a board and pat both sides with paper towels, pressing gently so the paper draws off the surface moisture. Run a fingertip along the center of each fillet to feel for pin bones, and pull any you find with tweezers. A dry surface lets the seasoned butter cling, and the butter is what holds the crust. Move on when the fish feels tacky rather than wet and a fresh towel comes away almost dry.

  2. 2Make the seasoned butter

    Melt the ¼ cup (50 ml) butter in a small saucepan over low heat. Stir in the salt, pepper, onion powder and garlic powder until no dry clumps remain. Take the pan off the heat so the butter stays liquid without browning. It is ready when the butter is fully melted and smells clearly of garlic and onion.

  3. 3Mix the coating and spread half on the tray

    In a bowl, stir together the flour, cornmeal and Italian seasoning. Keep mixing until the yellow grains and green herb flecks are spread evenly through the white flour. Spread half of the mix over the bottom of the shallow tray in an even layer. Keep the other half in the bowl. Move on when the tray bed is level, with no bare patches.

  4. 4Dip the fillets in butter and lay them on the coating

    Dip one fillet at a time into the seasoned butter, turning it so both sides are coated. Lift it and let the excess drip back into the pan for a moment. Lay it on the coating bed in the tray, then repeat with the rest, leaving a little space between them. Each fillet should sit pressed into the mix, with its underside fully covered.

  5. 5Cover the tops with the rest of the coating

    Sprinkle the remaining coating over the fillets, letting it fall from your fingers in an even shower. Press it on lightly with your palm so it sticks to the butter. Tip any loose mix from the tray onto the edges and sides. Move on when no glossy, buttered fish shows anywhere.

    Why the coating is split in two

    Dipping buttered fish into a full bowl of mix turns the bowl into wet clumps. A bed underneath and a shower on top keeps the mix dry, so the crust fries up even and crunchy on both sides.

  6. 6Fry the first side in foaming butter

    Heat the skillet over medium-high heat and add the 2 tbsp butter. When it has melted and is foaming, lay the fillets in, away from you, with space between them. Leave them alone for 5 minutes so the crust can set; moving them early tears the coating. The first side is ready when the underside is golden and the fish has turned opaque a little way up the sides.

  7. 7Flip, finish and check the temperature

    Slide a thin spatula fully under each fillet and turn it in one motion. Cook the second side for 5 minutes. Then push the thermometer probe into the thickest part of the largest fillet. The fish is done when it reads at least 158°F (70°C), both sides are golden brown, and the flesh flakes white at the center.